Skip to content
Newly installed manifold with flow meters, pump and PEX lines on a bare wall

Licensing

Plumbing License in NC (2026): How to Get a North Carolina Plumbing Contractor License

By· Founder, Made For BuildersReviewed

Summary

North Carolina plumbing licenses at a glance

North Carolina's Board licenses plumbing, heating, fuel piping and fire sprinkler contractors and technicians: 31 license qualifications in all. For plumbing, P-I covers any building and P-II covers single-family detached dwellings only. Technicians work for licensed contractors, and smaller restricted licenses cover exterior piping or water heater replacement.

North Carolina plumbing licenses (NC Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors, checked 2026-11-10)
Plumbing Contractor P-IPlumbing Contractor P-IIPlumbing TechnicianRestricted Limited Plumbing (RLP)
Issued byState Board of Examiners of Plumbing, Heating and Fire Sprinkler ContractorsSame BoardSame BoardSame Board
ScopePotable water and drain/waste/vent piping in any buildingThe same systems in single-family detached dwellings onlyEmployed by contractors or firms; Class I or Class IIExterior building sewer piping and other exterior work
Experience2 years (4,000 hours) on-site full-time; up to 2,000 hours may be academic or technical training2 years (4,000 hours), same ruleClass I: 18 months (3,000 hours); Class II: 15 months (2,500 hours)9 months (1,500 hours)
ExamPlumbing exam 4.0 hours, plus Business and Law 1.5 hoursSamePlumbing Technician exam 4.0 hours2.0 hours, plus Business and Law 1.5 hours
Exam application fee$150, non-refundable$150, non-refundable$150, non-refundable$150, non-refundable
License activation fee$150 (form valid through 9/30/2026)$150 (same form)$75, or $150 in some cases$150
RenewalEvery year by December 31; no continuing educationSameSameSame
Source: nclicensing.org Applicant Information page, Contractor License Definitions (2026-06), Exam Information (2026), License Activation Form and FAQ. The activation form on the Board's site says it is valid through 9/30/2026; check the current form before you pay.

Requirements change

The Board sets these rules and fees and can change them between our checks. Confirm every requirement with the State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors before you apply, hire or quote.

Business vs personal

Do you need a license to run a plumbing business in North Carolina?

Yes. G.S. 87-21 treats anyone who, for a valuable consideration, installs, alters or restores plumbing, or offers to, as engaged in the business of plumbing contracting. The statute sets two classes: Class I for all structures and Class II for single-family detached residential dwellings. The license is listed in the business's name.

The Article applies to the installation or replacement of water heaters, boilers, gas furnaces and air handlers, among other equipment. Installing a plumbing system on property intended for sale or to be used primarily for rental also counts as contracting, with or without payment, unless an exemption applies.

  • Qualified individual: each place of business of a licensed firm must have at least one listed qualified individual regularly on active duty to supervise and direct all licensed work. The work may be done by the licensee or by the firm's W-2 employees.
  • No moonlighting: the license must be listed with the Board in the name in which business is being conducted, and can only be used for contracting and permitting in that name.
  • If the qualifier leaves: all contracting activity, including quoting, bidding, permits and work in progress, must cease until another licensee is put in place as the firm's qualifier.
  • More than one license: you can hold any license you qualify for. Fuel piping privileges are already included in the plumbing and heating group licenses.

Steps

Steps to get a North Carolina plumbing license

Document the experience, apply with the $150 exam fee and a background check, wait for approval, take the exam with PSI within 90 days, then send the License Activation Form and fee within 45 days of passing. The Board says processing applications currently averages six weeks.

  1. Experience and exam

    For the P-I or P-II contractor exam, show 2 years (4,000 hours) of on-site full-time experience in plumbing or heating, whether or not a license was required for the work performed. Up to one-half (2,000 hours) can be academic or technical training. Military personnel and spouses may receive credit for experience gained during active service. The exam is given daily at seven testing centers, must be taken within 90 days of the notification date, and you must bring all allowed reference books. The plumbing contractor exam runs 4.0 hours, plus a 1.5-hour Business and Law exam, which is waived for some current contractor license holders. If you fail, you must wait 90 days before retesting.

  2. Insurance and bond

    The Board pages, forms and G.S. 87-21 text we read do not set a statewide insurance or bond amount for a plumbing license. Local permit offices, general contractors and customers may ask for proof of insurance, so check before you quote.

  3. Business registration

    The SBA says you need to choose a business structure before you register your business with the state, and most states require registration with the Secretary of State's office or a business agency. The IRS issues an EIN online, in minutes and for free. Check that your company name is available with the Board and the North Carolina Secretary of State before you list the license under it.

After you pass, submit the completed License Activation Form and fee within 45 days, or you will have to retest. The form on the Board's site lists $150 for Plumbing Class I and Class II. For the same steps in other states, see the plumbing license guide and how to start a plumbing business.

Keeping the license

Renewing a North Carolina plumbing license

All licenses from this Board expire on December 31 each year. The renewal period opens 90 days before, usually on October 1. There is no continuing education requirement: it was eliminated on December 31, 2012. Renewals paid after January cost $25 more, and there is no grace period for working on an expired license.

  • No grace period: in the Board's words, there is NO GRACE PERIOD following the expiration of a license. Bidding, contracting and installing must stop until you renew.
  • Late fee: G.S. 87-22, as quoted by the Board, adds $25 if you do not renew and pay during the month of January.
  • Up to three years: an expired license may be renewed for up to three years after expiration with back fees and late fees. After that, the Board requires reexamination.
  • How: online with a major credit card (a convenience fee applies) or with the printable form and a check or money order.

To compare renewal cycles, continuing education and late fees across our five markets, see plumbing license renewal.

Combination wrench resting on a wet stainless-steel sink

Moving to North Carolina

Licensed in another state: reciprocity and neighbor states

The Board states that there are no license reciprocity agreements with any other state. There are two partial routes: a technical exam waiver with South Carolina for plumbing and HVAC contractors, and the Neighbor State License Recognition Act for North Carolina residents licensed in Georgia, South Carolina, Tennessee, Virginia or West Virginia.

  • South Carolina waiver: the technical exam is waived, but applicants must pass the North Carolina business law exam.
  • Neighbor State License Recognition Act: applies to individuals who are currently permanent residents of North Carolina and hold a current license in one of those five states. They may be eligible for equivalent licensure.
  • Experience from other states: experience hours from other states can be submitted with a regular application.

Other states

Plumbing licenses in the other states we cover

North Carolina is one of five US markets in the Partner Program, with Texas, Florida, Georgia and Arizona. Each has its own regulator and its own ladder of licenses. The state-by-state comparison, with sources and check dates, is in the plumbing license guide.

First jobs

After the license: getting your first plumbing jobs

With the license active, the work is filling the calendar at a margin. Start with your own Google Business Profile and website, add one or two lead sources, and measure each one by cost per closed job rather than cost per lead.

Licensed and ready for work?

Through the Partner Program, we build and run a local brand for your trade and ZIP codes. You answer the calls and do the work. The commission is 20% of the labor on service and repair jobs, and 15% of the net on installations and replacements, with no setup fee and no monthly fee: how commission works. You do the work under your own license and insurance. We are not a contractor.

FAQ

North Carolina plumbing license questions

How long does it take to get your plumbing license in NC?

The experience sets the pace: 2 years (4,000 hours) for the P-I or P-II contractor exam, of which up to 2,000 hours can be academic or technical training. After you apply, the Board says processing averages six weeks, you have 90 days to take the exam, and 45 days after passing to activate the license.

How hard is the NC plumbing exam?

The Board does not publish pass rates. The plumbing contractor exam lasts 4.0 hours plus a 1.5-hour Business and Law exam, and you must bring the reference books on the Board's list. If you fail, you can attend an exam review in Raleigh and retest after 90 days. The general contractor exam is run by a different board.

Do HVAC technicians need to be licensed in NC?

HVAC work falls under the same Board as plumbing. Heating Group 3 Class I, for example, covers forced air heating and cooling systems of fifteen (15) tons or less in any building, and the Board also issues heating technician licenses for people employed by contractors. For the other HVAC rules, see the HVAC license guide.

How long is plumbing school?

North Carolina does not require a school. It accepts up to one-half (2,000 hours) of the contractor experience as academic or technical training, which the Board equates to 45 quarter hours or 30 semester hours. Nationally, the BLS says most plumbers learn their trade through a 4- or 5-year apprenticeship.

Does North Carolina accept plumbing licenses from other states?

Not through reciprocity: the Board has no license reciprocity agreements with any other state. South Carolina contractors can get the technical exam waived but must pass the North Carolina business law exam, and North Carolina residents licensed in five neighboring states may qualify under the Neighbor State License Recognition Act.

Next steps

Where to go from here

  • Your trade

    How the Partner Program works for your trade: the jobs, the licensing check and how commission is paid.

    See your trade
  • Run your numbers

    A free calculator to check the margin on a job before you price it.

    Open the calculator
  • Working in this state

    Who regulates your trade here, the official sources and where we are recruiting partners.

    See the state page
  • Licensing

    What you need to run a trade business legally, from official sources.

    All licensing guides
  • How the Partner Program works

    We build and run a local brand for your trade in your area. The calls ring on your phone and you pay commission only on jobs you close.

    See the Partner Program
  • Apply to the Partner Program

    Calls from your own area under a local brand. Commission only on closed jobs.

    Apply

Last reviewed: